Web hosting providers - the Monitor when the scene is at about
the Monitor when the scene is at about where you want to trim. You can thenuse the Previous Frame and Next Frame buttons to zero in on the exact framewhere you want to set a trim point. To trim all frames to the left of the current frame (within the selected clip), choose Clip.Set Start Trim Point. Or, to trim off all frames to the right of thecurrent position, choose Clip.Set End Trim Point. Play the entire movie (orat least from before the trim point) to verify that you like the shortened scene. If you don t like the results, click the scene again in the Timeline and chooseClip.Clear Trim Points. Then you can start over with new trim points if you like. As you ll learn in the section Managing Clips, later in this chapter, you canalso delete trash from any clip by splitting the clip into two parts and delet- ing anything you don t plan to use. Overlapping ScenesIt s OK to make scenes in the Timeline overlap one another. Doing so will auto- matically produce a fade transition, where one scene (or song, or photo) willautomatically fade out as the other is fading in. How long the fade transitionlasts depends on how much overlap there is. If the clips in the Timeline are too small to see, keep clicking the Zoom (+ magnifying glass button) in the Timeline to zoom in until you can seeboth clips well. Use the horizontal scroll bar under the Timeline to scroll leftand right. To make two scenes overlap, make sure you re in Timeline view. Then click the scene to the right of the one you want to overlap it with. Drag that sceneslightly to the left. Or choose Clip.Nudge Left to move the scene just a tinybit to the left. Then drag the Play Indicator to the left of the whole overlap andclick the Play button in the Storyboard/Timeline to see (or hear) the transition. If the transition is too short, you can nudge the scene on the right a little moreto the left. If the transition is too long, nudge the scene on the right a little tothe right. The two scenes (clips) will partially overlap, as at the bottom of Figure 18-11. The word Fadeappears in the transition bar where the scenes overlap. (Clickthe + or - sign to the right of the word Videoto show/hide the Transition bar.) When you play the movie, the first scene on the left will slowly fade out as thescene on the right slowly fades in. Spicing Up Your MovieAfter you ve dragged some clips to the Storyboard or Timeline, you can startspicing things up with some special effects, music, still photos, and titles. Let sstart with some titles.
Note: In case you are looking for affordable and reliable webhost to host and run your j2ee application check Vision J2ee Web Hosting services.